1 pair of plaster - molds
Dimensions 1: 29 cm x 29 cm x 4.5 cm

Dimensions 2: 21 cm x 21 cm x 4.5 cm

1 pair of plaster - molds
Dimensions 1: 29 cm x 29 cm x 4.5 cm

Dimensions 2: 21 cm x 21 cm x 4.5 cm

 

Due to the good material properties, aging-resistant and dimensionally stable,
of high-quality PP plastic (such as masonry buckets) are the molds
(with proper treatment) unlimited reusable.

In addition, you can through natural color pigments, you too
preserved with us, a stone coloring or other decorative
Create colorations.
Of course it is new.

Instructions:

This is how it's done:

A release agent is always required. We recommend our spec. Release agent "VARIO" (available from us), with which you spray the molds thinly.

Then the filling material (e.g., precast concrete from the hardware store, additional additions of cement (about 5 kg) is often required).

Important! When filling the molds you have to avoid the air bubbles, the forms z. For example, place it on a board and hit it with the hammer several times during filling, or remove the air with a vibrating table.

 

Do you want to make the concrete yourself, pay attention to the correct mixing ratio

(1 part cement and 3 parts sand - grit 4-8). The mixture should not be too thin.

The drying time until removal from the mold should be at least 24/36 hours.

Only after approx. 2-3 weeks is the concrete block to be processed without danger of breakage (with diamond disc etc.)